Apr. 18, 2025
1. If there is a hole requirements, there will be a lathe or deep -hole machine with machining pores, and
the non -perforated requirements will also process the central hole of the end face during the turning process.
2. The internal hole of the end -facial hole in the appearance of the end surface: Take a secondary clip with a unilateral one -sided by the embryo.
Different basis can also cause deviations, and it is necessary to further achieve the two -time clamping correction or high -precision grinding process.
3. Deficiency problems: unstable processing size, difficulty in concentric requirements for high requirements,
cumbersome process and having a lot of human resources in equipment, and a long time losses.
Double -headed car process:
1. One sequence is held at the middle of the middle ends at the middle of the embryo. There is a pores that can be completed directly
in this process. In the case of the same embryo benchmark, the two ends of the processing part of the processing part are guaranteed.
2. The two -sequence is based on the processing of the same -handed concentric base at both ends
and the overall outer diameter of the processing on the CNC vehicle to complete the product car cutting process.
3. If there is a relative position key slot, milling square, and sales hole on both ends of the motor axis, you can control the
relative angle of the relative angle of the relative angle by adding the spindle milling function through the double -headed car milling shaft function. The bias of the fixture and the fixture.
Regarding the conventional combination of automatic line:
1. Embryo and process transfer automatic feeding system-dual-headed
lathe — CNC car — teeth-rubbing machine-local high-frequency treatment --- grinding --- online detection-finished product
2. The combination of the processing process depends on product needs, and
the process that some products are not needed or design can be connected or decreased in the entire line.
